Muratec MFX-1300/1700 - Manual (Page 19)

1.8
Getting started
Turning off the transport mode
Important: After unlocking the mirror carriage (see page 1.5), you must turn the
transport mode off by following procedures.
When the machine is in the transport mode, the LCD shows:
To turn off the transport mode:
1 Press Program key, *, E .
2 Select Off by pressing or . Then press ENTER to turn off the transport mode.
The mirror carriage will move to the home position.
Important: If you must reship the machine, turn on this mode to move the mirror car-
riage to the transport position (in step 2, above, press
or to set the
transport mode to O n), then power off and lock the mirror carriage using
the mirror carriage locking plate (see page 1.5).
Adjust the monitor speaker s volume
You can set the volume of the monitor speaker.
1 Press MONITO R / CALL on the control panel. You now should hear a dial tone.
And press or of the cursor key. The LCD indicates the volume:
2 To turn the volume up, press .
To turn the volume down, press .
3 Press MONITO R / CALL again to hang up.
Loading paper
Acceptable paper size and cassette capacity
Paper source Paper type Paper size Capacity
Paper cassette Plain paper* 1 Letter , Legal , Half-letter 500 sheets
Letter , Legal , Half-letter ,
Plain paper* 1 A4 , A5 , A6 , F4 , 50 sheets
Bypass Tray Executive , Custom-sized* 2
Envelopes DL , CM10 , Monarch 1 sheet
Postcard 3.9
″ Ч
5.8
″
(100 Ч 148mm) 20 sheets
Transparency* 3 Letter 20 sheets
* 1 Paper weight: 60 90 g/m 2
* 2 (3.8 8.5) inches (5.5 14.0) inches (Width Length) : It only can use if the optional
Printer Controller is attached.
* 3 W e recommend: 3M PP2500 for laser printers or equivalent
Note: Do not use any paper which has been creased, wrinkled or has absorbed any
moisture.
Loading paper in paper cassette
Before you load paper, note the following:
After you loaded paper in paper cassette, you must need to tell your machine
which size of the paper, letter-, legal- or half letter-sized, you loaded.
You can do this by the Setting of the paper size operation. (See next page.)
Note: If you will be using letter-sized paper, there s no need to adjust the cassette;
your machine is initially set for Letter-sized paper. Simply attach the LT R
sticker to the outside of the paper cassette.
1 Open the paper cassette from the front of your machine by gently pulling it toward
you.
** Tel Mode **
Volume: ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Mirror Locked :Off
/ /Enter
Mirror Locked :On
/ /Enter
Mirror Locked