Muratec MFX-1300/1700 - Manual (Page 44)

2.13
Basic operation
Stacking multiple copies
1 Press C O P Y / FA X to change to Copy mode.
2 Press S O R T to turn the sort setting off .
Note: The default setting of sorting is O n. To change the default setting, see
page 4.7.
3 Place your original document in ADF face up, or on the FBS glass face down just
as you would to send a fax.
4 Enter the document size by pressing the D O C U M E N T SIZE .
5 Using the numeric keypad to enter the number of copies you want (up to 99).
6 As needed, set the following:
Select document type and adjust image contrast
Set copy reduction or enlargement ratio
Note: For details about each items, see Making copy settings, pages
2.15 2.16.
7 Press STA R T .
Note: To stop the copying, press STO P .
Sorting multiple copies (using ADF )
Note: You cannot use the FBS glass for sorting multiple copies.
1 Press C O P Y / FA X to change to Copy mode.
2 Make sure the LED on S O R T glows, which means the sort setting is turned on.
Note: If it does not glow, press S O R T to turn it on.
3 Place your original document in ADF face up, just as you would to send a fax.
4 Set the document size by pressing the D O C U M E N T SIZE .
5 Using the numeric keypad to enter the number of copies you want (up to 99).
6 As needed, set the following:
Select document type and adjust image contrast
Set copy reduction ratio
Note: For details about each items, see Making the copy settings, page 2.15.
7 Press STA R T .
Note: To stop the copying, press STO P .
Enlarged or reduced copies
Your fax machine is capable of enlargement and reduction when copying.
Note: The copy enlargement and reduction rate setting is available only for copying,
not for faxing.
Important: Copy enlargement is available only for copying using the FBS ; it is not
available for copying using the ADF .
1 Press C O P Y / FA X to change to Copy mode.
2 Place your original document in ADF face up, or on the FBS glass face down just
as you would send a fax.
Note: If you want to enlarged copy, use FBS glass.
3 Enter the document size by pressing the D O C U M E N T SIZE .
4 Choose an enlargement or reduction ratio using or of the cursor key.
You can reduce to 78%, 64 % or 50 % of the original size
O R
You can enlarge to 129% or 200 %
O R
Press Z O O M to turn the Z O O M light on, and adjust the ratio at 1% steps using or
of the cursor key. You can enter the ratio between 50% and 200%.
O R
Directly enter any percentage between 50 % and 200 % by following procedure.
1. Press #.
2. Using the numeric key to enter your desired ratio (50 to 200).
3. Press # again.
129%: Half-letter (5.5
″
8.5
″
)
→
Letter (8.5
″
11
″
)
78%: Legal (8.5
″
14
″
)
→
Letter (8.5
″
11
″
)
Helpful Tip: You can set the copy reduction or enlargement ratio to Auto . (See
Setting copy auto, page 4.7.) If the Auto is set and you set the
document size by pressing D O C U M E N T SIZE , the machine automati-
cally reduce or enlarge the original size (you entered) to fit on the
paper size you selected.