Muratec MFX-1300/1700 - Manual (Page 129)

Just in case
What you see on the LCD What it means/What to do
Document Full You tried to enter an document into an F-Code
box, but the machine has reached its capacity (30
documents). Delete documents stored in
F-Code boxes until the machine will let you pro-
ceed.
Document Jam An original document jam while you are using
ContStor Enter/Cancl the ADF for either faxing or copying. See page 5.1
for instructions on clearing the jam.
Document Stored You tried to erase a batch box which contains at
least one document. Erase the document(s), then
try again.
Enter No. (0-32) You tried to enter a call group number greater than
32. Your machine can maintain 32 call groups,
numbered 1-32 (call group 0 covers all the
groups). Determine the correct call group identifier
number and enter it, instead.
Enter Reduce/Enlarge You tried to copy your document on the paper
other than Letter, Legal or Half letter sized paper
using the bypass tray, or the calculated reduction
or enlargement ratio is out of the acceptable range
(50 200 %) when the copy reduction or enlarge-
ment ratio is set to Auto .
Enter the reduction or enlargement ratio manually
although a part of the image might be lacked, or
change the paper for copying.
Enter Scan Size When you using the FBS (Flatbed scanner) glass,
you must manually enter the scan size of your
document. Press
D O C U M E N T SIZE to choose the
size.
Feeder In Use The command you re trying to enter requires the
use of the
ADF , which is already in use. W ait for the
machine to stop using the ADF , then try again.
What you see on the LCD What it means/What to do
Hang Up Phone The optional handset is off-hook.
Hang it up, making sure the upper part of the
handset presses down on the hook button.
In Relay Box You tried to store a document for polling in an F-
Code box which is set to be a relay box.
Select an F-Code box which is set to be a bulletin
box, then try again.
In Secure Box You tried to store a document for polling in an F-
Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
In Use in P OneTouch You tried to erase the F-Code box or Batch box,
which is programmed in the programmable one-
touch key.
Erase the programmable one-touch key that con-
tains the F-Code box or Batch box you want to
erase, then try again.
Invalid I.D. Code The F-Code box I . D .code you entered isn t valid.
Try re-entering your F-Code box I . D .code.
Invalid Number You pressed a key which has no function during
the current operation.
Invalid Paper Size If the optional printer controller is attached to your
machine, it can use the special sized paper with
the bypass tray. However, it should be used only
for the PC printing, it cannot be used for copying.
So, if you tried to copy onto the special sized
paper with bypass tray, this message will appear.
Invalid Passcode The protection passcode you entered isn t valid.
Repeat the operation, entering the correct protec-
tion passcode.
Line Busy You tried to erase a document which someone is
polling from your machine. W ait for the fax to com-
plete the polling operation, then try again.
5.6