Muratec MFX-1300/1700 - Manual (Page 132)

Just in case
What you see on the LCD What it means/What to do
Too Many Steps You tried to enter too many steps for a macro. You
can enter up to 60 steps into a macro key.
Unable to Reduce In the reduction copy using the ADF , if the
calculated ratio is smaller than minimum reduction
ratio (50%), this message will appear and you can-
not make the reduction copy.
Use the
FBS glass, however parts of the image
might not be copied.
Use FBS Glass You tried to enlargement copy using the ADF .
Your machine cannot enlargement copy from the
ADF . Please set your document on the FBS glass to
make the enlargement copy.
Errors
When sending faxes, your machine occasionally runs into communications errors. These
can be caused by anything from lightning to telephone line interference. (These same
factors cause the static, or line noise, you sometimes hear on phone calls.) They also
can be caused by problems with the fax machine at the other end of the line.
Often, simply trying your call again is all that s necessary. However, if the problem per-
sists regularly,call your local telephone company for help. If that doesn t help and the
problem persists regularly, call your authorized Muratec dealer.
Error reports
When an error occurs, your fax machine prints an error report. Each fax error report lists
an error message which includes:
A possible solution to the problem
The sending location (if the remote fax stores a Location ID of its own)
The result which is a special error code.
A sample of the document s first page.
Kinds of error codes
The error code listed in the Result column of the error report indicates the specific
problem encountered:
D codes Occur while dialing
R codes Occur during reception
T codes Occur during transmission
Specific errors
Following are some error codes you may see on an error report:
Dialing errors
D .0.3, The remote unit didn t respond, the call couldn t be completed or STO P was
D .0.8 pressed during dialing. Re-try the call. If your machine repeats the message,
call the remote fax unit s operator and verify that unit is operating properly.
D .0.2 The remote unit is busy. Try the call again.
D .0.6, Either the remote unit didn t respond, the call somehow didn t go through or
D .0.7 STO P was pressed during dialing. Try the call again.
5.9