Settings for copying, Copy scan settings, Adjusting the copy print settings – Muratec MFX-1300/1700 User Manual
Page 117
Copy scan settings
Default setting: Primary document type: Text, Primary contrast: Normal
Two different settings tell your machine how to scan documents. The initial factory set-
tings are probably right for most applications, so try using them before changing any of
these settings:
Primary document type Sets the document type for your documents. Choose
either Text, Text&Photo, or Photo.
Primary contrast Sets how light or dark you want copied documents to be.
Note:
These primary settings you choose effect your copy activity only.
To set these modes:
1
Press Program key,
B
,
3, 0, 1,
ENTER
.The
LCD
asks you to select a resolution:
2
Press or
until the mode you want appears. In this example, we ve chosen
P H O TO
.
3
Press
ENTER
to save the setting. The
LCD
asks you to select a contrast setting:
4
Press or
until the mode you want appears. In this example, we ve chosen
light contrast.
5
Press
ENTER
to save the setting.
By following the steps above, you ve set your defaults for scanning. Before copying doc-
uments, you can override these default scan settings for that copying.
To override the default document type and contrast settings before copying a document:
Press
D O C U M E N T
to change the document type.
Press
C O N T R A S T
to change the contrast.
Once your document is copied, your machine returns to its default settings.
Adjusting the copy print settings
Default setting:
Margin: 24 mm
Your machine s print margin for copying is measured in millimeters (mm). We ll define
print margin by explaining how it s used:
When an original document is scanned, the machine measures the document s length
and compares it to (a) the length of your selected paper (not include the print margins)
plus (b) the print margin you set. If the length of the document is longer than (a) and (b)
put together, your machine prints the document on more than one sheet.
Note:
A print margin setting of 24 mm will print most documents as single pages. Try
this combination first and then, only if you have problems with it, select different
settings.
1
Press Program key,
B
, 3, 0, 2,
ENTER
.The
LCD
shows the current print margin for
copying:
2
Use the numeric keypad to enter the print margin you want. If necessary, press
or
to move the cursor. In this example, we ve chosen 20mm.
3
Press
ENTER
to save the setting.
Margin
(00-85mm):20
Margin
(00-85mm):24
Contrast :Light
/
/Enter
Contrast :Normal
/
/Enter
Doc. Type:Photo
/
/Enter
Doc. Type:Text
/
/Enter
Changing the default settings
4.6
Settings for copying