Settings for dialing, Changing the dialing pause length, Changing redial settings – Muratec MFX-1300/1700 User Manual
Page 116
Changing the default settings
Changing the dialing pause length
Default setting: 2 seconds
The pause is set by the factory to last two seconds, but you can set it to last as long as
ten seconds if necessary.
To change the pause length:
1
Press Program key,
B
, 2, 0, 5,
ENTER
.
2
Use the numeric keypad to enter the length you want for the dialing pause. Here,
we ve chosen nine seconds.
Note:
The length setting requires two digits. Always enter a leading zero for
lengths less than 10 seconds.
3
Press
ENTER
to save the setting.
Changing redial settings
Default setting: Number of redial: 2 times, Redial interval: 1 minute
I
ts up to you how many times the fax redials a number and how long it waits between
redials (that length of time between calls is the redial interval).
To program the redial settings:
1
Press Program key,
B
, 2, 0, 4,
ENTER
.
2
Use the numeric keypad to enter the number of redials you want. Choose from 2
to 15 redials. In this example, we ve entered 03.
Note:
Enter a leading zero when entering a quantity less than 10.
3
Press
ENTER
to save the setting.
4
The
LCD
now shows:
5
Use the numeric keypad to enter the length you want between redial attempts.
Choose from 1 to 5 minutes.
In this example, we ve chosen 4.
6
Press
ENTER
to save the setting.
Redial Interval
Interval (1-5):4
Redial Interval
Interval (1-5):1
# Of Redials
# (02-15):03
# Of Redials
# (02-15):02
Dialing Pause
Time (02-10):09
Dialing Pause
Time (02-10):02
4.5
Settings for dialing