Muratec MFX-1300/1700 - Manual (Page 37)

2.6
Basic operation
12 At the end of the operation, your fax machine beeps and displays:
Important: Whenever you transmit a document, what actually appears on the
top line of the display depends on information stored in the remote
fax. The line may even be blank.
Note: If the call fails, see Redialing, page 2.6.
Sending a fax using MONITO R / CALL key or a handset
You also can fax a document using either the monitor speaker or the optional
handset to dial the call.
Note: If you want to use MONITO R / CALL key, you should assign it to a Soft key in
advance. (See page 3.16.)
Note: In this function, you cannot send a fax using the FBS glass.
1 Insert the document to the ADF .
2 Adjust resolution and contrast if necessary.
3 Obtain a dial tone, either by:
Pressing MONITO R / CALL
or
Lifting the optional handset.
In either case, the LCD shows:
4 Enter the fax number by using the numeric keypad.
Also, enter access codes with the number, just as for a regular phone call.
5 When you hear fax tones from the remote unit, press STA R T .
Note: If a person answers the phone, use the optional handset to tell that per-
son that you re trying to send a fax. When you hear fax tones, press
STA R T .
6 If you re using an optional handset, hang up after pressing STA R T .
7 At the end of the operation, your fax machine beeps and displays:
Note: If the call fails and you used MONITO R / CALL to dial, press MONITO R / CALL to
hang up. Or if you ve pressed STA R T to begin the fax transmission, press
STO P to end it.
Also see Redialing manually, below, if the call fails.
Redialing
Automatically fax redialing
If your fax call fails, your machine automatically redials it. In this Auto Redial mode, your
fax automatically redials the number up to two times at one minute intervals.
Note: You can change the redial time and interval settings. (See Changing redial set-
tings, page 4.5.)
While in the Auto Redial mode, the machine can continue to receive faxes and can
make as many as 99 fax transmissions.
Note: If you used either the MONITO R / CALL key or a handset to dial the call, you must
redial manually (see below).
Note: If the last redial attempt fails, your machine may print (and/or display) error
messages.
Redialing manually
You can always redial calls manually. And you must redial manually if you used either
the MONITO R / CALL key or an optional handset to dial the failed call.
Note: To use REDIAL / PA U S E key, you should assign it to a Soft key in advance. (See
page 3.16.)
To redial a fax call manually without using the MONITO R / CALL key or an optional
handset:
1 Set the document and set the resolution and contrast.
2 Press REDIAL / PA U S E . The LCD will show:
View Redial History
0:1234567890
919725552009
** Complete **
** Tel Mode **
919725552009_
** Tel Mode **
_
919725552009
** Complete **