Muratec MFX-1300/1700 User Manual

Page 105

Advanced features

Important:

While in

Mode 1, any autodialer numbers you use must include the

.This also applies to autodialer numbers used with batch transmission

(see page 3.11) or programmable one-touch keys (see pages 3.35 3.48).

Note:

If you select either Mode 1 or Mode 2 and will be using batch transmission, you
must store the

access code for the remote unit within the appropriate batch

box.

If you chose Mode 2 as you autodial, load the code

In this mode, you don t have to add the

to the autodialer setting. Instead, you enter

the

manually each time you autodial:

Dial the number as you normally would, using the autodialer. Here, we ve pushed
one-touch key

The machine now asks for the

Use the numeric keypad to enter the

Press

STA R T

.Your machine dials the number.

Note:

If you select either Mode 1 or Mode 2 and will be using batch transmission (see
page 3.11), you must store the

access code for the remote unit within the

appropriate batch box.

Dialing from the numeric keypad while using the

mask

If you ve specified Mode 1 use star power

Enter the phone number, then press the *(star ) key and enter the

The

always goes last. For example, to dial 19725550911 with a

of 123456 ,

enter 19725550911*123456:

Press

STA R T

.The

disappears from the display, and your machine dials the

desired phone number.

If you ve specified Mode 2 the machine guides you

Enter the phone number as usual.

Press

STA R T

.The

LCD

shows:

Use the numeric keypad to enter the

Press

STA R T

.Your machine dials the number.

Performing batch transmission while using the

mask

Note:

The following instructions presume you are familiar with how to set and use
both your machine s autodialer and its batch transmission feature. If you need
to review, see pages 3.1 3.8 for more on the autodialer and/or page 3.11 for
more on batch transmission.

If you ve specified Mode 1 or Mode 2

Important:

Any autodialer number you use with batch transmission must include the

. (To review how to include this information in an autodialer number,

review the Mode 1 instructions under Autodialing while using the

mask, page 3.51.)

Before sending a batch transmission the first time, you must store the

within its

batch box.Here s how:

Follow the steps for creating or modifying a batch box (pages 3.11 3.12).
The

LCD

asks for the fax number (here, we re working with batch box 1):

Enter an autodialer number, or use the numeric keypad to enter the fax number,
to which the batch transmission should go.

Important:

If you re entering a number from the numeric keypad, enter the fax
number, followed by the *(star ) key and then the

1:Fax Number
_

Enter PIN Number
123456_

Enter PIN Number
_

Press Start
19725550911_

Press Start
19725550911*123456_

Enter PIN Number
1057_

Enter PIN Number
_

3.52