Muratec MFX-1300/1700 - Manual (Page 14)

1.3
Getting started
1 C O P Y light Glows when the machine is in the Copy mode.
2 FA X light Glows when the machine is in the Fax mode.
3 A L A R M light Glows when a problem occurs during fax communication, printing
or scanning. The light stays on until the machine prints a Check Message report.
4 C O M M .light Glows when the machine is communicating with another machine.
5 M E M O RY RECEIVE light Glows when the machine is receiving an incoming fax
document into its electronic memory.
6 Soft Keys Shortcut keys. Any function that can be turned on or off can be pro-
grammed into these three keys. If the light above one of these keys glows, this
indicates the setting that s been programmed into it (see page 3.16) is turned on.
These keys are programmed at the factory to turn the following functions on or
off
:
Soft key 1: E N E R G Y S AVING Pressing this key, you can make the machine to be
in the Sleep mode immediately.
Note: If the optional printer controller has been installed to your machine, this
key will be
ONLINE key.
Soft key 2: S O R T Press to turn the Sort feature on or off .
Soft key 3: COMBINE Press to turn the Combine feature on or off .
Note: If your machine is MFX-1300, this key is FA X & C O P Y to turn the Fax & Copy
feature on or off .
7 B Y PA S S Press to change the paper size of the bypass tray.
8 C O P Y C O U N T Press to see the number of total printed pages on the LCD .
9 B R O A D C A S T Press to send a broadcast fax (sending the same document to
more than one location).
10 G R O U P Press to set up a fax transmission to a call group, a set of fax numbers
which will receive the same document in one fax operation.
11 A D VA N C E D FUNCTIONS
In Fax mode: Chooses from following several fax options delayed transmission,
Polling, F-Code transmission, F-Code polling and Batch transmission.
Or, in Copy mode: Chooses from following copy options Nega/Posi copy,
Combine copy (only for MFX-1700) or Ultra copy (only for MFX-1700).
12 C O M M . C A N C E L / CONFIRM . Press to stop the transmission, or to review pending
fax commands and the activity journal.
13 STA R T Press to begin a fax transmission, reception or copying.
14 STO P Stops the current operation and ejects a document from the ADF .
Control Panel Overview
1 2 3 4 5 6 7 8 9 10 11 12 13 14
15 16 17 18 19 20 21 22 23 24 25 26 27 28