Muratec MFX-1300/1700 - Manual (Page 36)

2.5
Basic operation
Sending a fax using the FBS glass
1 Press C O P Y / FA X to change to Fax mode.
2 If there s a document in the ADF , remove it.
3 Open the platen cover.
4 Place the document face down on the FBS glass and align it with the document
scale on the right, then gently close the platen cover.
The document should be aligned to the right front corner.
Important: Gently close the platen cover so that you don t catch your hands,
possibly injuring them.
When a thick document, such as a book, is on the
FBS glass,
do not press strongly from the top of the platen cover. This may
break the FBS glass and cause an injury.
5 Press D O C U M E N T SIZE to select the document size, letter (displayed as Ltr), legal
(Legl) or half-letter (HLtr). (Half-letter is 8.5
″
wide 5.5
″
tall.)
6 Adjust resolution and contrast if necessary.
7 Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to dial out from an office telephone system, or 1 for long-
distance.)
8 Press STA R T .
By pressing STA R T , you ve just given your machine a command. In turn, your
machine gives this action a command number as it scans the fax document.
This command number appears on the first line of the L C D for a few seconds:
You ll need this command number to cancel the transmission or to print a stored
document (see pages 2.7 2.8).
Then your machine will scan the document into the memory.
While your machine scans the document, the
LCD will show:
9 When the scanning is done, the LCD will show:
If you want to send more pages, proceed to step 10.
Otherwise, press
STA R T to start the transmission, and skip to step 11.
10 Place the next page, then press NEXT D O C to start scanning.
Note: If necessary, select the document size (see step 5).
To send any more pages, repeat steps 9-10.
Otherwise, press
STA R T to start the transmission, and skip to step 11.
11 N o w, everything is up to the machines yours and the one you re dialing.
When it makes contact, your machine transmits the stored document from mem-
ory.
Important: If you want to cancel a transmission while scanning the document,
press the
STO P key.
If you want to cancel a transmission in progress, use the Review
Commands function. See Reviewing or canceling commands,
page 2.7.
Start Scan
→ → NextDoc
Tx Start
→ → Start
919725552009
Ltr NextDoc Mem100%
== Command:01 ==
Press Start
919725552009_