Crankcase cover installation, Adjusting governed idle, Topgoverned speed adjustment – Generac Power Systems TXP User Manual
Page 91
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
C R A N K C A S E C O V E R I N S T A L L A T I O N
Position engine with crankshaft
in a vertical position. Rotate
crankshaft to place timing mark
on can gear at 12 o’clock. In
stall gasket and install cover,
MAKE SURE GOVERNOR GEAR TEETH
ARE IN MESH - use long thin screw
driver to rotate governor gear, if
necessary.
g o v e r n o r
s h a f t
a d j u s t m e n t
Adjust governor lever as outlined in Test 32, Page, 4,18.
A D J U S T I N G G O V E R N E D I D L E
Adjust governed idle as outlined in Test 23, Page 4,14,
T O P G O V E R N E D S P E E D A D J U S T M E N T
Adjust governor as outlined in Test 32, Page 4,18.
Issued 5-78
16,3