Generac Power Systems TXP - Manual (Page 90)

Loosen nut and remove governor lever.
Rotate crankshaft to place crankshaft
gear timing mark at about the 10
o’clock position. Remove E-ring and
thick washer at outer end of governor
shaft. Governor shaft will slide down
into gear case. Rotate crankshaft
back and forth slightly until shaft
can easily be removed,
G O V E R N O R S H A F T I N S T A L L A T I O N
Install thin thrust washer onto
governor shaft before installing
shaft into crankcase. Slide the
shaft up into position, rotating
crankshaft to obtain clearance.
Install thick washer, then retain
shaft with E-ring, Install gover­
nor lever onto shaft and tighten
nut lightly. Rotate shaft until
. crank touches rib, as shown at
right. IF GOVERNOR SHAFT IS NOT
IN PROPER POSITION BEFORE ASSEMB­
LING CRANKCASE COVER, CORRECT
GOVERNOR ADJUSTMENT WILL NOT BE
OBTAINED,
G O V E R N O R G E A R I N S T A L L A T I O N
Install governor gear and thrust
washer onto shaft in crankcase
cover as shown at right. Make
sure the gear rotates freely. Be
sure weights and cup move freely
with no evidence of binding.
16.2 Issued 5-78