Issued 3-78 – Generac Power Systems TXP User Manual

Page 65

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

REMOVE VALVES

Valve springs are retained by

COLLARS and RETAINERS, as shown

above.

To remove exhaust valve, insert

valve'Spring compressor upper jaw

between the valve spring and the

valve chamber. Insert lower spring

compressor jaw below the retainer.

Compress the spring, remove collars

from stem, release the spring, and

finally remove the spring.

Intake valves have a stem seal,

retained by the valve spring.

To remove Intake Valve, slip upper

jaw of valve spring compressor ov

er the top of the valve chamber.

Place the lower jaw of the spring

compressor between spring and ret

ainer, Compress the valve spring,

then remove retainer.

Lubricate the valve stem and pull

Intake Valve out slowly, to avoid

damage to the Valve stem seal.

8 . 2

Issued 3-78