beautypg.com

Generac Power Systems TXP User Manual

Page 79

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

The oil dipper must be properly

installed on the number 1 connect­

ing rod, as shown at right. A

special washer is installed be­

tween dipper and bolt head.

OIL M A K E - U P SYSTEM

The Oil Make-up System functions to prevent dangerously low engine

crankcase oil levels during operation. The system consists of (1) an

Oil Make-up TANK with low oil level shutdown switch, (2) an Oil Make­

up PUMP, (3) an Oil Make-up PROBE, and (4) interconnecting lines.

t

The Oil Make-up' Pump will not act

while the tip of the Oil Make-up

Probe is submerged in oil. If oil

level in the crankcase should drop

to about the 48 ounce level, the

tip of the Probe will be exposed to

crankcase vacuum/pressure pulses.

These pulses actuate the Oil Make­

up Pump diaphragm and the pump ac­

tion then draws oil from the Tank. ■

When the Probe tip is again submerg­

ed in oil, pumping action stops.

If Oil Make-up Tank oil level

should drop below the OIL CHANGE

LEVEL arrows on the tank side,

the float-operated Low Oil Level

Shutdown Switch will ground the

engine ignition system and the

engine will automatically shut

down.

During initial filling of the engihe

crankcase, approximately 56 ounces

(3^ pints) of oil is added. This a-

mount of oil brings the oil level up

to the oil dipstick FULL mark. The

Oil Make-up System will not start to

pump oil into the crankcase until

oil level has reached the 48 ounce

point, about halfway between the dip­

stick FULL mark and ADD 1 PINT mark.

Issued 4-78