Generac Power Systems TXP - Manual (Page 54)

ALTERNATOR 6
r e a r b e a r i n g c a r r i e r
REMOVAL
1. Remove Control Panel as outlined in Section 5.
■Xtic.-;
i!.
- ■ 1
2. Remove the Fuel Shutoff Solenoid
Clamp screw. Tape o.r cover the open
end of the Fuel Filter to prevent
entry of dirt. Lay the Filter, Sol­
enoid and hoses out of the way.
4. Use a 7/16 inch socket to remove
the 4 stator bolts. Use a wood or
fiber mallet to tap each projecting
corner of the Rear Bearing Carrier.
When Rear Bearing Carrier Is free
of the Rotor bearing, slide the wire
bundle through the snap bushing and
remove the Rear Bearing Carrier.
3. Use a
k
inch nut driver to remove
the 3 screws that retain the Fan
Guard. Remove the Fan Guard.
INSPECTION
1. Check closely for cracks, or other damage.
2. Check condition of snap bushing. Replace, if damaged.
3. Inspect threaded holes for condition of threads, damage, etc. Repair
or retap, as required.
Issued 3-78
6.1