Generac Power Systems TXP - Manual (Page 82)

G E N E R A L
STARTER MOTOR 14
PLASTIC
CAP
PINION
’ pin '' SPpViSa SPBINO
iNo C ap
An exploded view of the starter is shown above. The starter uses a
gear type engagement, similar to an automobile. Energizing the starter
motor causes the helix on the starter to drive a pinion gear into eng­
agement with a ring gear. The pinion gear then cranks the engine.
C H E C K S T A R T E R M O T O R D R I V E
#
When the starter motor is energized, the pinion gear should move out
on its helix to engage the ring gear. If the motor drive does not re­
act properly, inspect helix-and pinion gear for freedom of movement.
If sticking or binding occur, the condition must be corrected. Pinion
must move freely on its helix. DO NOT LUBRICATE DRIVE ASSEMBLY.
D I S A S S E M B L E S T A R T E R M O T O R D R I V E
Clamp starter drive cap in a vise.
DO NOT CLAMP MOTOR SHELL IN VISE.
Use two screwdrivers to remove the
plastic cap, as shown. If cap be­
comes damaged, it must be replaced,
Use a 1/8 inch diameter punch and
a hammer to drive the roll pin out.
Rest retainer in a wood V-block, as
shown.
Issued 5-78 14.1