Generac Power Systems TXP - Manual (Page 52)

2,
At
rear of Panel, (a.) disconn­
ect spark plug wires from Ignition
Coil, (b) disconnect the wire con­
nectors A and B,. and (c.) cut the
tie wrap that holds Wires #2 and
#6 to the stator bolt.
3, Remove the Panel top cover.
4. Remove wire nuts and disconnect
wires #11 and #22 to Sensing Tran­
sformer, as well as Wire #55 to
Diode Dl. Disconnect wire #66 at
terminal strip. Disconnect wire #
77 at battery charge circuit brea­
ker. Disconnect wires #11 and #33
from main circuit breaker and pull
through the snap bushing.' Remove
wire nuts from two. wires #T2 and
pull through snap bushing. Pull all
wires through snap bushing at
rear floor of panel.
5. At the rear exterior floor of
the control.panel, locate wires #
1, #2, #4 and #6 that connect into
the white receptacle. Use a small
screwdriver or pen knife to "un­
lock” each female pin from its. re­
ceptacle slot, while carefully pul­
ling down on each wire. Remove all
four wires from the white receptac­
le.
Issued 3-78 5.5