Carburetor removal, Carburetor disassembly, Carburetor reassembly – Generac Power Systems TXP User Manual

Page 86: Issued 5-78

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

C A R B U R E T O R R E M O V A L

The carburetor and intake manifold are removed as an assembly. Discon

nect fuel line from integral fuel pump. DO NOT BREAK PLASTIC NIPPLE ON

FUEL PUMP. Remove screws that retain intake manifold to engine.

Governed Idle Tang

Idle Speed

Adjustment Screw

Stop Tang

Disconnect governor link from

governor lever.

Disconnect vacuum line from its

fitting at fuel pump. Remove

carburetor and intake manifold,

C A R B U R E T O R D I S A S S E M B L Y

Remove idle and needle, valves.

Replace if damaged. Remove fuel

pump body. Remove upper carbur

etor body, float and float valve.

Check float for leakage, replace

if damaged. Check float valve and

seat, replace if damaged or worn.

DO NOT CLEAN CARBURETOR IN ANY

SOLVEl^T UNLESS ALL RUBBER SEALS

AND NYLON PARTS HAVE BEEN REMOVED,

C A R B U R E T O R R E P A I R

When reassembling carburetor, use

new parts where necessary. Always

use NEW GASKETS, Carburetor repair

kits are available. The float valve

has a Viton tip. Float valve seat

is pressed into the carburetor body,

15.2

.1*

Issued 5-78