Generac Power Systems TXP - Manual (Page 87)

F L O A T V A L V E S E A T R E P L A C E M E N T
#
Press new seat flush with body, us­
ing old seat and screw as a driver.
DO NOT PRESS SEAT BELOW SURFACE OF
BODY.
Clamp the head of a self-threading
screw in a vise. Then turn carburet­
or body to thread screw into seat.
Continue turning carburetor to draw
the seat out. Install a new seat in­
to carburetor body. New seat has a
starting lead.
Install float valve,
C H E C K I N G F L O A T L E V E L
«
With body gasket, float valve and
float installed on upper body, the
float should be parallel to the
body mounting surface.
If not parallel, bend tang on float
until just parallel. DO NOT PRESS
ON FLOAT TO ADJUST.
Issued 5-78 15.3