Generac Power Systems TXP User Manual
Page 53
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6, Use a
\
inch nut driver to rem
ove brush inspection cover screw.
Remove brush inspection cover. Use
a % inch nut driver to remove the
2 screws that retain the brush
holder. Cut the tie wrap that ret
ains the brush wires to the rear
bearing carrier.
7. Use a 7/16 inch socket to remove
the 4 bolts that retain the control
panel ho the stator can. Lift stra
ight up and remove the entire cont
rol panel.
5.6
Issued 3-78