Ier bit definitions -12, Table 17-6 – Intel PXA255 User Manual
Page 582
17-12
Intel® PXA255 Processor Developer’s Manual
Hardware UART
Enabling DMA requests also enables a separate error interrupt. For additional information see
Set bit 7 of the IER to enable DMA requests. The IER also contains the unit enable and NRZ
coding enable control bits. Bits 7 through 4 are used differently from the standard 16550A register
definition.
Note:
MCR[OUT2] is a global interrupt enable, and must be set to enable UART interrupts.
Note:
To ensure that the DMA controller and programmed I/O do not access the same FIFO, software
must not set DMAE (bit 7) while TIE (bit 1) or RAVIE (bit 0) are set to 1.
This is a read/write register. Ignore reads from reserved bits. Write zeros to reserved bits.
Table 17-6. IER Bit Definitions
Physical Address
0x4160_0004
Interrupt Enable Register (IER)
PXA255 Processor Hardware UART
Bit
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
reserved
DM
AE
UU
E
NR
Z
E
RT
OI
E
MI
E
RL
S
E
TIE
RA
VI
E
Reset
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
0
0
0
0
0
0
0
0
Bits
Name
Description
31:8
—
reserved
7
DMAE
DMA REQUESTS ENABLE:
0 = DMA requests are disabled
1 = DMA requests are enabled
6
UUE
UART Unit Enable:
0 = the unit is disabled
1 = the unit is enabled
5
NRZE
NRZ CODING ENABLE.
NRZ encoding/decoding is only used in UART mode, not in infrared mode. If the slow
infrared receiver or transmitter is enabled, NRZ coding is disabled.
0 = NRZ coding disabled
1 = NRZ coding enabled
4
RTOIE
RECEIVER TIME OUT INTERRUPT ENABLE (Source IIR[TOD]):
0 = Receiver data Time out Interrupt disabled
1 = Receiver data Time out Interrupt enabled
3
MIE
MODEM INTERRUPT ENABLE (Source IIR[IID]):
0 = Modem Status Interrupt disabled
1 = Modem Status Interrupt enabled
2
RLSE
RECEIVER LINE STATUS INTERRUPT ENABLE (Source IIR[IID]):
0 = Receiver Line Status Interrupt disabled
1 = Receiver Line Status Interrupt enabled
1
TIE
TRANSMIT DATA REQUEST INTERRUPT ENABLE (Source IIR[IID]):
0 = Transmit FIFO Data Request Interrupt disabled
1 = Transmit FIFO Data Request Interrupt enabled
0
RAVIE
RECEIVER DATA AVAILABLE INTERRUPT ENABLE (Source IIR[IID]):
0 = Receiver Data Available (trigger threshold reached) Interrupt disabled
1 = Receiver Data Available (trigger threshold reached) Interrupt enabled