4 interrupt enable register (ier), 4 interrupt enable register (ier) -11, Dll bit definitions -11 – Intel PXA255 User Manual

Page 581

Intel® PXA255 Processor Developer’s Manual

17-11

Hardware UART

Load these divisor latches during initialization to ensure that the baud rate generator operates
properly. If each divisor latch is loaded with a 0, the 16X clock stops. The divisor latches are
accessed with a word write.

The baud rate of the data shifted in to or out of a UART is given by the formula:

For example, if the divisor is 24, the baud rate is 38400 bps.

The divisor’s reset value is 0x0002.

Table 17-4

and

Table 17-5

describe the DLL and DLH registers.

These are read/write registers. Ignore reads from reserved bits. Write zeros to reserved bits.

17.5.4

Interrupt Enable Register (IER)

The IER, shown in

Table 17-6

, enables the five types of interrupts that set a value in the Interrupt

Identification register (IIR) (refer to

Section 17.5.5

). To disable an interrupt, software must clear

the appropriate bit in the IER. Software can enable some interrupts by setting the appropriate bit.

The character timeout indication interrupt is separated from the received data available interrupt to
ensure that the processor and the DMA controller do not service the receive FIFO at the same time.
When a character timeout indication interrupt occurs, the processor must handle the data in the
receive FIFO through programmed I/O.

BaudRate

14.7456 MHz

16xDivisor

(

)

----------------------------------

Table 17-4. DLL Bit Definitions

Physical Address

0x4160_0000 (DLAB=1)

Divisor Latch Register Low (DLL)

PXA255 Processor Hardware UART

Bit

31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9

reserved

DLL

Reset

Bits

Name

Description

31:8

—

reserved

7:0

DLL

Low byte compare value to generate baud rate

Table 17-5. Divisor Latch Register High (DLH) Bit Definitions