TA Triumph-Adler DC 2325 - Manual (Page 85)

Sending Functions
ADVANCED OPERATION GUIDE 2-11
2
1-sided/2-sided Selection
Select the type and binding of original depending on the original.
The table below lists the binding directions for each original type.
NOTE: To scan colored 2-sided originals using the optional document
processor, you need to add memory to the machine. Contact to your
service representative.
Use the procedure below to select the original type and binding direction
when sending scanned originals.
1 Place the originals on the platen.
2 Press the Send key.
3 Press [Type of Original/Transmission] and then [2-sided/Book Original]
4 Press [1-sided], [2-
sided], or [Book].
5 If you selected [2-sided] or [Book], you should also select the binding
direction and press [Original Orientation] to select the direction in which the
original is set on the platen.
6 Press [OK].
7 Specify the destination, and press the Start key to start sending.
Original Type Binding
1-sided Sheet Original 1-sided —
2-sided Sheet Original 2-sided*
* Only when the optional document processor is used.
Binding Left/Right,
Binding Top
Open Book Original such
as magazine and book Book Binding Left,
Binding Right
Status 10/10/2007 10:10
Ready to send.
Press [OK] to display
Destination
1
1-sided
2-sided/Book Original
Place original .
2-sided
Book
Right Left
Binding
Top Edge Top
Original
Orientation
Cancel OK Add Shortcut
the image.