TA Triumph-Adler DC 2325 - Manual (Page 198)

System Menu
6-30 ADVANCED OPERATION GUIDE
3 Use the [+] or [-] key
to enter the margin
widths for L/R and T/
B(-0.75 - +0.75).
You can use the
number keypad to
enter the number
directly.
4 Press [OK].
Collate/Offset
Set the defaults for Collate/Offset. The table below shows the available
settings.
NOTE: Refer to page 1-12 for Collate/Offset.
Use the procedure below to set the default Collate/Offset settings.
1 Press the System Menu key.
2 Press [Common Settings], [Next] of Function Defaults, [T] and then
[Change] of Collate/Offset.
3 Select the defaults
for Collate and
Offset respectively.
4 Press [OK].
Common Settings - Margin Default
Select the default margin width.
Use [-]/[+] or the numeric keys to enter a number.
L/R(-0.75 - +0.75)
0.23
Cancel OK
Status 10/10/2007 10:10
# Keys
Paper is remaining in Document Processor.
"
T/B(-0.75 - +0.75)
0.47
# Keys
"
Item Description
Collate Off Collate not performed.
On Collate performed.
Offset Off Offset not performed.
Each Set
(Each Page) Offset performed. (If [Off]) is selected of
Collate, it is performed [Each Page].)
Common Settings - Collate/Offset
On Off
Cancel OK
Status 10/10/2007 10:10
Collate
Each Set Off Offset
Select the default collate/offset setting .