TA Triumph-Adler DC 2325 - Manual (Page 196)

System Menu
6-28 ADVANCED OPERATION GUIDE
6 Press [OK].
E-mail Subject/Body
Set the subject and body automatically entered (default subject and body)
when sending the scanned originals by E-mail.
NOTE: Refer to the Operation Guide for sending E-mail.
Use the procedure below to set the default e-mail subject and message
body.
1 Press the System Menu key.
2 Press [Common Settings], [Next] of Function Defaults, [T], and then
[Change] of E-mail Subject/Body.
3 Press [Subject] to
enter an E-mail
subject not more
than 60 characters.
NOTE: Refer to the Operation Guide for entering characters.
4 Press [OK].
5 Press [Body] to enter an E-mail subject not more than 500 characters.
6 Press [OK].
7 Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the
measurement ranges that can be set.
Common Settings - E-mail Subject/Body
Set the default subject and body .
Subject
Body
Cancel OK
Status 10/10/2007 10:10
Input units Range
Inch models 0 to 2" (in 0.01" increments)
Metric models 0 mm to 50 mm (in 1 mm increments)