TA Triumph-Adler DC 2325 - Manual (Page 30)

Copying Functions
1-16 ADVANCED OPERATION GUIDE
Output Destination
You can use the procedure below to select an output destination such as
the optional document finisher for your copies.
NOTE: Optional output destinations include the job separator, document
finisher and the built-in finisher.
The table below shows the available output destinations.
NOTE: To change default destination for copies, refer to Output Tray on
page 6-20 for details.
Use the procedure below to select the output destination.
1 Press the Copy key.
2 Press [Org./Paper/Finishing] and then [Output Tray].
3 Select the output destination for finished copies.
When you select
[Finisher tray],
select the
orientation of output
copy, Face Up (print
facing up) or Face
Down (print facing
down).
4 Press [OK].
5 Place the originals in the document processor or on the platen. Press the
Start key to start copying.
Destination Description
Top tray Top tray of the machine (where copies are
stored)
Finisher Tray*
* Copy output orientation can be selected either as face-up (print
facing up) or face-down (print facing down).
Tray of the optional document finisher or built-in
finisher
Job Separator Tray Optional job separator
Status 10/10/2007 10:10
Ready to copy. Copies
Cancel OK
Output Tray
Press [OK] to display
Add Shortcut
Finisher Tray
Face Up
Face Down
Top Tray
1
the image.