TA Triumph-Adler DC 2325 - Manual (Page 242)

System Menu
6-74 ADVANCED OPERATION GUIDE
3 Press [+] or [–] to
enter the time until
Auto Panel Reset is
turned on.
You cannot use the
number keypad to
enter this value.
4 Press [OK].
Auto Low Power Mode
You can specify the amount of time to wait before Auto Low Power Mode.
Specify a value from 1 - 240 minutes (1 minute increments).
For more information on Auto Low Power Mode, refer to the Operation
Guide .
Use the procedure below to set the Auto Low Power Mode time.
1 Press the System Menu key.
2 Press [T], [Date/Timer] and then [Auto Low Power Mode].
3 Press [+]/[–] or the numeric keys to enter the time until Auto Power Mode
is turned on.
4 Press [OK].
Auto Sleep
If no job runs for a certain period of time, automatically enter Sleep Mode.
Refer to the Operation Guide for Sleep Mode.
Auto Sleep ON/OFF
Select whether to use Auto Sleep or not.
NOTE: Time remaining before Auto Sleep can be modified as necessary.
Refer to Sleep Timer below about the procedures.
Use the procedure below to select the interface.
1 Press the System Menu key.
2 Press [T], [Date/Timer] and then [Change] of Auto Sleep.
Date/Timer - Reset Timer
Cancel OK
Status 10/10/2007 10:10
Set the amount of time to wait before automatic panel reset.
Use [-]/[+] to enter a number.
(5 - 495)
sec.