Using the postscript printer driver with windows – Epson WorkForce AL-MX300DN User Manual
Page 260
Mac OS X
Recommended
OS Version
Mac OS X 10.5.8 or later
Computer
Power Mac G3, G4, G5, iMac, eMac, PowerBook G3, G4, or iBook
Note:
If you use binary data for the network connection, you need to set Binary to On in the PS3 Menu on the
control panel. For details about the settings, see the Network Guide. If you use the printer with a local
connection, you cannot use binary data.
Using the PostScript printer driver with Windows
To print in the PostScript mode, you will have to install the printer driver. See the appropriate sections
below for installation instructions according to the interface that you are using to print.
Installing the PostScript printer driver for the USB interface
Note:
❏ Installing the printer software for Windows may require administrator privileges. If you have
problems, ask your administrator for more information.
❏ Turn off all virus protection programs before installing the printer software.
1. Make sure that the printer is turned off. Insert the printer Software Disc into your CD-ROM
drive.
Note:
If your computer does not have a CD/DVD drive, download the driver from the Epson website.
2. Connect your computer to the printer with a USB cable, then turn on the printer.
Note for Windows Vista users:
Without the Windows driver or the Adobe PS driver, the display shows “Found New Hardware.” In
this case, click Ask me again later.
AL-MX300 Series User's Guide
About the Printer Software 260