Epson WorkForce AL-MX300DN - Manual (Page 169)

Cannot Connect to Computer
No connectable computers are found. WSD scan device driver for this printer might not be installed in
the computer, or the computer’s power might be turned off.
Cannot fax because of report
An error occurs if you perform fax transmission when a power off report cannot be printed after
turning on the printer.
Cannot make settings because fax job is being received
The printer might be receiving fax jobs from a computer. Wait until the fax jobs are finished and then
try again.
Cannot print report
This message appears when you specify printing a report or list that does not exist in the System
Report Printing
menu in the System Information menu.
Cannot recognize USB flash memory
The printer cannot recognize the USB memory connected to the printer. Check the connection to the
USB memory or replace it with a new one.
Cassette Error 001/ Cassette2 Error 002
The wrong cassette unit is installed. Turn off the printer, remove the cassette unit, and then turn on the
printer.
Check Paper Size
The paper size setting is different from the size of paper loaded in the printer. Check to see if the correct
size of paper is loaded in the specified paper source.
To clear this error, select Clear Warning from Reset Menu in the Common Settings menu. See
“Accessing the each menu” on page 126 for instructions.
Check Media Type
The media loaded in the printer does not match the paper type setting in the printer driver. Media that
matches only the paper size setting will be used for printing.
AL-MX300 Series User's Guide
Using the Control Panel 169