Epson WorkForce AL-MX300DN - Manual (Page 173)

Fuser Needed Soon
This message indicates that the fuser unit is near the end of its service life. You can continue to print
until the Replace Fuser message appears.
To clear this warning message and continue printing, select Clear All Warnings from Reset
Menu
in the Common Settings menu. For instruction about accessing the control panel menus, see
“Accessing the each menu” on page 126.
Hang Up Receiver
The fax operation is completed. Hang up the hand set of the external telephone connected to the
printer.
"ID Card Copy" is set. Cancel "ID Card Copy".
When ID Card Copy is set to On, you cannot change the Zoom setting. Set ID Card Copy to Off.
Image Optimum
There is insufficient memory to print the page at the specified print quality. The printer automatically
lowers the print quality so that it can continue printing. If the quality of the printout is not acceptable,
try simplifying the page by limiting the number of graphics or reducing the number and size of fonts.
To clear this error, select Clear Warning from the Reset Menu in the Common Settings menu. See
“Accessing the each menu” on page 126 for instructions.
Install Fuser
The fuser unit is not installed in the printer. Install the fuser unit. For details, see the documentation
supplied with the fuser unit.
! Caution:
If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must
touch one of these areas, turn off the printer and wait 40 minutes to allow the heat to subside before
doing so.
Install Photoconductor
The photoconductor unit is not installed in the printer. Install the photoconductor unit. For details,
see the documentation supplied with the photoconductor unit.
Install Toner Cartridge
AL-MX300 Series User's Guide
Using the Control Panel 173