Epson WorkForce AL-MX300DN - Manual (Page 233)

The printout was on the wrong side of the paper when I did duplex printing.
Cause What to do
In duplex printing mode, the back side of the paper is
printed first. However, if Convert to Simplex is set to
Odd Page
, and a job has an odd number of pages, the last
page is printed on the front side of the paper.
For single page jobs, printing is done on the front side of
the paper whether Convert to Simplex is set to Odd
Page
or 1 Page.
For jobs with three or more pages, set Convert to Simplex to
Off
or 1 Page to do duplex printing.
For jobs with just one page, set Convert to Simplex to Off to do
duplex printing.
Problems Using Options
To confirm your options are installed correctly, print a status sheet. See “Printing a Configuration
Status Sheet” on page 220 for details.
Paper does not feed from the optional paper cassette
Cause What to do
The paper guides are not set correctly. Make sure that the paper guides in the optional paper cassettes
are set to the correct paper size positions.
The optional paper cassette may not be installed
properly. See “Optional Paper Cassette Unit” on page 186 for instructions
on installing an optional paper cassette unit.
The paper source setting may not be correct. Make sure you have selected the proper paper source in your
application.
There may be no paper in the paper cassette. Load paper into the selected paper source.
Too many sheets may be loaded in the paper cassette. Make sure that you have not tried to load too many sheets of
paper. For the maximum paper capacity for each paper source,
see “General” on page 269.
The paper size is not set correctly. Make sure to set the paper guides in the optional paper cassette
correctly.
AL-MX300 Series User's Guide
Troubleshooting 233