Epson WorkForce AL-MX300DN - Manual (Page 172)

Fax was not received normally. If the error occurs again, contact your dealer or a qualified customer
support person for assistance.
Fax report cannot begin to print
The printer might be receiving a fax. Try again after the fax receiving is completed.
Faxing cannot begin
Send the fax again after fax reception or the PC to FAX operation is completed.
Feed Roller C1 Needed Soon/ Feed Roller C2 Needed Soon
This message indicates that the feed roller C1 or C2 is near the end of its service life. You can continue
to print until the Replace Feed Roller C1 or Replace Feed Roller C2 message appears.
To clear this warning message and continue printing, select Clear All Warnings from Reset
Menu
in the Common Settings menu. For instruction about accessing the control panel menus, see
“Accessing the each menu” on page 126.
File Name Already Exists
You cannot save the file because the same file name already exists in the USB memory or shared folder.
Rename or delete the file in the USB memory or shared folder.
File Size Exceeds Limit
Transmission failed because the size of the data being sent exceeded the limit specified on the printer.
Change the Max File Size setting in E-mail Settings or make the file smaller.
Filling toner xx min
The printer is filling toner. Wait until this message disappears. Do not turn off the printer while
filling.
Folder Memory Full
There is insufficient memory in the specified folder on the network to carry out the current task. Press
the Stop button to cancel the job.
Folder Write Error
Saving data to the specified shared folder on the network failed.
AL-MX300 Series User's Guide
Using the Control Panel 172