Epson WorkForce AL-MX300DN - Manual (Page 177)

Ready
The printer is ready to receive data and print.
Ready to Copy
The printer is ready to copy.
Reboot to apply settings
You selected No when Do you want to reboot to apply the settings? was displayed. To
clear this error, select Clear Warning from Reset Menu in the Common Settings menu. See
“Accessing the each menu” on page 126 for instructions.
Replace ADF Maintenance Unit
The ADF maintenance unit has reached the end of its service life and needs to be replaced. If this error
occurs, consult your dealer.
Replace Feed Roller C1/ Replace Feed Roller C2
The feed roller C1, C2 has reached the end of its service life and needs to be replaced. If this error
occurs, consult your dealer.
Replace Fuser
The fuser has reached the end of its service life and needs to be replaced. For details about replacement,
see the instructions that come with the fuser unit.
! Caution:
If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must
touch one of these areas, turn off the printer and wait 40 minutes to allow the heat to subside before
doing so.
Replace Photoconductor
The photoconductor unit has reached the end of its service life and needs to be replaced. For details
about replacement, see the instructions that come with the photoconductor unit.
Replace Toner Cartridge
The toner cartridge has reached the end of its service life and need to be replaced. For details about
replacement, see the instructions that come with the toner cartridge.
AL-MX300 Series User's Guide
Using the Control Panel 177