Epson AcuLaser MX20DNF - Manual (Page 238)

Canceling Printing
Press the Stop button on the printer’s control panel, and then press the F3 button to select Yes.
To cancel a print job before it is sent from your computer, see “Cancelling a Print Job” on page 63.
Printing in the PostScript 3 Mode Problems
The problems listed in this section are those that you may encounter when printing with the PostScript
driver. All procedural instructions refer to the PostScript printer driver.
The printer does not print correctly in the PostScript mode
Cause What to do
The printer’s emulation mode setting is incorrect. The printer is set to the Auto mode by default, so that it can
automatically determine the encoding used in the received print
job data and select the appropriate emulation mode. However,
there are situations where the printer cannot select the correct
emulation mode. In this case, it must be set manually to PS3.
Set the emulation mode through the SelecType Emulation Menu
on the printer. See “Emulation Menu” on page 152.
The printer’s emulation mode setting for the interface
that you are using is incorrect. The emulation mode can be set individually for each interface
which receives print job data. Set the emulation mode for the
interface you are using to PS3.
Set the emulation mode through the SelecType Emulation Menu
on the printer. See “Emulation Menu” on page 152.
The printer does not print
Cause What to do
The Save as File check box is selected on the Output
Options sheet in the Print dialog box (for Mac OS X
10.3.9). Clear the Save as File check box on the Output Options sheet in
the Print dialog box.
An incorrect printer driver is selected. Make sure that the PostScript printer driver that you are using to
print is selected.
Epson AcuLaser MX21/MX20 Series User's Guide
Troubleshooting 238