SMA Sunny Data Control V.5.0 - Manual (Page 151)

Troubleshooting SMA Technologie AG
Technical Description SDC-TEN081450 153
14.3. 1 FAQ
• The commissioning of an integrated Bluetooth interface in a PC was not successful.
- With Sunny Data Control it is not possible to work with the integrated Bluetooth solution or
with the Bluetooth stack. Set up the virtual COM port as described in the Bluetooth stick
manual.
• Which Bluetooth IDs are still free?
- Choose "Options / Settings/Communication."
- Choose "Bluetooth" from the drop-down list "Connection via".
- Click on .
- Click on .
- Choose "Bluetooth IDs" from the "Display type" drop-down menu.
- Click on
• How do I find out which Bluetooth ID is set on my inverter?
There are two possibilities.
- Switch off the inverter's AC circuit breaker and secure it against accidental switching on.
- Switch off the signaling contact of the supply voltage and secure it against accidental
switching on (if present).
- Remove the Electronic Solar Switch ESS
- Wait until the inverter is completely deactivated. Check to see that LEDs, display and, if
present, the fault sensor are off.
- Reconnect the Electronic Solar Switch ESS.
- Switch on the AC circuit breaker again.
- During the following booting procedure of the inverter, the setting of the Bluetooth ID
switch is shown, among other things.
or
- Open the inverter as described in its manual.
- Read the position of the Bluetooth ID switch inside the inverter.
5 After the installation of the
Bluetooth stick has been
completed, the integrated
Bluetooth interface does not
function. • Unfortunately SMA cannot guarantee that the
installation of several sticks and stacks on a PC will
not create problems. There are installations which
behave dominantly, or which configure the system in
such a way that competing installations no longer
work.
No. Error description Cause