Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 86)

86 K2 Media Client System Guide September 7, 2006
Chapter 4 Managing Internal Storage
yellow/green once a second.
Unbind LUN
You can only unbind one LUN at a time. Also make sure the controller is not busy
with other processes, such as rebuilding a disk. If the controller is busy, the unbind
LUN operation fails.
CAUTION: Unbinding destroys all data stored on disk modules.
To unbind a LUN, do the following:
1. In the tree view, right-click the LUN and select Unbind LUN .
2. If the K2 Media Client is online, messages appear “…offline mode now?” and
“…continue?”. Click Yes to put the K2 Media Client in offline mode.
AppCenter channels go offline.
3. When warning messages appear “…destroy all existing media…” and “Are you
sure?”, click OK to continue.
4. The Progress Report opens and displays unbind progress.
5. When progress reports 100% complete, the LUN is unbound.
6. Restart the K2 Media Client.
NOTE: Remember that the LUN 0 (disks 0_0 and 0_1) is the system drive. Do not
attempt disk operations on the system drive.
Bind Luns
When you bind a LUN, you select unbound disks and create a new LUN. The Storage
Utility places this new LUN at the bottom of the list and numbers it accordingly.
However, disk numbers are enforced by the chassis slot in which the disk resides.
!