Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 150)

150 K2 Media Client System Guide September 7, 2006
Appendix C Rack-mounting
Rack mounting the control point PC drawer
The pull out PC notebook drawer kit consists of two slide assemblies with front and
rear brackets fitted and a drawer. The kit does not include rack screws or cage nuts.
1. On both slide assemblies, release the inner rail from the outer slide as follows:
The plastic release lever moves up on the left-hand rail and down on the right-hand
rail. You might need a slotted screwdriver to move the plastic release lever.
2. Fasten the inner rails to the drawer with the screws provided. The screws are on the
drawer.
3. Adjust both slide assemblies as illustrated. This is necessary to provide the proper
inset for the flip-down drawer front. With this adjustment to the slide assemblies,
it is not necessary to change the position of the rails fastened to the drawer.
Move the plastic release lever
to release the inner rail.