Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 113)

September 7, 2006 K2 Media Client System Guide 113
Configuring a K2 Media Client for the K2 Storage System
Network Configuration
This page configures both
control and media (iSCSI)
network connections. The
K2 Media Client actually has
four Gigabit Ethernet ports,
but ports 1 and 3 are
configured as a teamed pair
(the control team), while
ports 2 and 4 (the media
connections) are individual.
The teamed pair shares an IP
address and appears on this
page as a single port.
The top port is the port (teamed) over which the K2 System
Configuration application is communicating with the K2 Media Client.
If correctly configured, it is already assigned the control network IP
address, which is displayed in the window.
Select
Media Connection #1 and click Modify . A network configuration
dialog box opens. Configure as follows:
• If a non-redundant K2 Storage System, enter the media network
IP address. Also enter the subnet mask.
• If a redundant K2 Storage System, enter an IP address for the “A”
media (iSCSI) network. Also enter the subnet mask.
If a non-redundant K2 Storage System, do not configure Media
Connection #2.
If a redundant K2 Storage System, select
Media Connection #2 and
click Modify . A network configuration dialog box opens. Enter an IP
address for the “B” media (iSCSI) network. Also enter the subnet mask.
Click
Next .
On this page… Do this…