Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 112)

112 K2 Media Client System Guide September 7, 2006
Chapter 7 External Storage
opens. Follow the on-screen text as described in the following table.:
On this page… Do this…
Page 1
Enter the IP address or network name for a K2 Media Client, as currently
configured on the K2 Media Client. You should configure your highest
bandwidth K2 Media Clients first, as this ensures load balancing is
correct. Refer to the load balancing topic earlier in this chapter for
information on load balancing.
For the Storage Access settings, leave
iSCSI selected.
Click Next
Software Configuration
This page checks the K2
Media Client for required
software.
If software with Yes in the Required column reports as Not Installed, you
must first install it on the K2 Media Client before continuing. Refer to
Chapter 5, “Managing K2 client system software” . After installing the
software, click Check Software . When all required software reports as
Installed, click Next .