Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 42)

42 K2 Media Client System Guide September 7, 2006
Chapter 2 Using K2 Media Client system tools
2. Use the up arrow or select folders to navigate to the folder in which you want to
save the configuration file.
3. Enter a name for the configuration file.
Do not name the file DefaultConfig.xml, as this name is reserved for the factory
default configuration file. Otherwise, standard Windows 2000 and up file naming
restrictions apply.
4. Click Save and Close .
To restore custom settings:
1. If you want to save current settings, you should save them as a configuration file
before continuing.
2. In the Configuration Manager, click the Load button.
The Open dialog opens.
3. Use the up arrow or select folders to navigate to the custom configuration file.
4. Select the custom configuration file.
5. Click Open .
The custom settings are loaded into Configuration Manager, but they have not been
saved and put into effect.
6. Click OK to save and apply settings, and to close the Configuration Manager.
Restoring default Configuration Manager settings
You can restore factory default settings as follows:
• You can restore some individual settings or groups of settings by selecting the
Default button which appears below the settings in the configuration screen.
• You can restore all the settings in Configuration Manager at once to their default
values as explained in the following procedure.
To restore all settings at once to their default values:
1. If you want to save current settings you should work through the previous
procedure “Saving and restoring Configuration Manager settings” before
proceeding.
2. In the Configuration Manager dialog, click Restore .
The default settings are loaded into Configuration Manager, but they have not yet
been saved and put into effect.
3. Click OK to save settings and close Configuration Manager.
K2 System Configuration
The K2 System Configuration application (K2 Config) is the primary tool for
configuring the K2 Storage System. Once the devices of the storage system are cabled
and are communicating on the control network, you can do all the configuration
required to create a working K2 Storage System using the K2 System Configuration
application.