Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 149)

September 7, 2006 K2 Media Client System Guide 149
Making Rack Slide Adjustments
3. Push the chassis toward the rack until the chassis sections lock into the intermediate
sections.
4. Press the stop latches in the intermediate sections and push the chassis toward the
rack until the latches snap into their holes.
5. Again, press the stop latches and push the cabinet fully into the rack.
6. Insert and tighten the front panel retaining screws.
Making Rack Slide Adjustments
After installation, binding may occur if the slide tracks are not properly adjusted. To
adjust the tracks:
1. Slide the chassis out approximately 10 inches.
2. Slightly loosen the mounting screws holding the tracks to the front of the rails and
allow the tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding
the chassis in and out of the rack several times.
4. Tighten the front panel retaining screws once the cabinet is in place within the rack
to complete the installation.
Stop Latch