Grass Valley K2 Media Client System Guide Oct.10 2006 - Manual (Page 146)

146 K2 Media Client System Guide September 7, 2006
Appendix C Rack-mounting
Rack mount hardware shipped with the K2 client system
Your K2 client system rack-mount kit comes with rack mounting hardware as shown.
NOTE: You must install
chassis section on the
K2 Media Client chas-
sis
Automatic
Latches
Rack Section
10-32 PHS
10-32 PHS
Screw
Flat
Nut
Bars
Flat Nut Bar
Intermediate
Section
Stop Latch
Rear
Mounting
Stationary
Section
NOTE: Right- hand and left-hand stationary section is
designated by the RH and the LH ma rked on the rails.
Stop latch holes should be towards
the bottom when slides are in place. (The right-hand rail is shown
above.)
Mounting Brackets