Emboss carrier taping standard (sot89-3pin), Taping information, Epson – Epson Power Supply S1F70000 User Manual
Page 229: Appendix taping information
6–6
EPSON
S1F70000 Series
Technical Manual
Appendix
TAPING INFORMATION
The emboss carrier taping standard is shown in the
following table and figure. This standard conforms to
Dimension code
Dimensions/angles (mm/
°
)
A
5.0
B
4.6
D
1.5 +0.1, –0.05
E
1.50
±
0.1
F
5.65
±
0.05
P1
8.0
±
0.1
P0
4.0
±
0.1
Dimension code
Dimensions/angles (mm/
°
)
P2
2.0
±
0.05
T
0.3
T2
2.3
W
12.0
±
0.2
W1
9.5
θ
30
°
Max.
There are no joints in either the cover or carrier tapes.
Less than 0.2% of the total device count is comprised
of non-sequential blanks. There are no sequential
blanks. This does not apply to the tape leader and
trailer.
Note
The tape thickness is 0.1 mm Max.
the EIAJ RCI00B electronic parts taping specification.
Each tape holds 1,000 devices.
Device cavity
T2
T
D
Feeder hole
Cross section with device position
Travel direction
E
F
B
θ
θ
A
W
P1
P0
P2
EMBOSS CARRIER TAPING STANDARD (SOT89-3pin)