Teac HS-2000 - Manual (Page 96)

96
TASCAM HS-2000
9 – Playlist mode
Playback control in playlist mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP [RETAKE] key to stop playback.
Press the . [MARK .] key or /[MARK /] key
to skip to the next take.
Press and hold them m [ ] or , [ ] key to
search backward or forward.
Press the . [MARK. ] or /[MARK /] key
while pressing and holding the SHIFT key to move
between marks.
Press and hold them m [ ] or , [ ] key while
pressing and holding the SHIFT key to search at high-
speed.
NOTE
On the • PLAY SETUP screen, you can set whether
only the currently selected take is played or whether
all the takes in the current session are played. You can
also enable and disable repeat playback. (See “Playback
settings (PLAY SETUP)” on page 102.)
Playback functions can also be performed using •
a remote control connected through the parallel
connector.
Using the call function
Press the CALL [CHASE] key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.
BWF-J cue point (playlist mode)
When the Follow BWF-J item is set to ON, if a BWF-J
cue point is detected during playback, the following
corresponding operation will occur. In addition, if the
BWF-J Tally Out item is set to ON, in response to each
BWF-J cue point, the cue signal and tally signal will be
output from the parallel remote connector.
BC$STANDBY
When an entry is selected, the transport locates
to the first BC$STANDBY point as the playback
start point. During playback, playback pauses
when this cue point is detected. In either case, a
BC$STANDBY tally is output.
BC$CM
During playback, when this cue point is
detected, a BC$CM CUE signal is output.
BC$END
During playback, when this cue point is
detected, a BC$END CUE signal is output.
BC$STOP
During playback, when this cue point is
detected, a BC$STOP CUE signal is output, and
playback stops.
BC$FILE
During playback, when this cue point is
detected, a BC$END CUE signal is output. If
there is a BC$STANDBY cue point in the next
entry, playback will move to it and pause at that
point. A BC$STANDBY tally is output.
BC$PAUSE
During playback, when this cue point is
detected, a BC$PAUSE tally is output, and
playback pauses.
Using the flash start function
Flash start playback is possible using a TASCAM RC-
HS32PD or RC-HS20PD (sold separately) or other remote
controller.
For details, see “Flash start function” on page 130.