Teac HS-2000 - Manual (Page 15)

TASCAM HS-2000
15
2 − Names and functions of parts
When REMOTE Select (pin 14) is set to high, it can be used
as an ordinary parallel controller.
When set to low, flash start mode is enabled. In addition,
depending on the Flash Page high/low setting (pin 20),
the key assignments are as follows.
Pin 14 Pin 20 Flash start take
Low High 1–10
Low Low 11–20
TALLY_BC_*: Use menu setting to switch output (OFF, ON)
(When an RC–SS20 is connected set output to OFF.)
TALLY_BC_STOP/CM/END: 250msec pulse output
TALLY_BC_STANDBY/PAUSE: Level output
The following example is of a connection that uses a fader
to start and stop playback of this device.
For information about the assignment of AUX 1–3 (pins
17–19) functions, see the “PARALLEL page” of “Remote
settings (REMOTE SETUP)” on page 106.
NOTE
When controlling this unit with an external device •
that is connected to the PARALLEL connector, by
simultaneously inputting PLAY and RECORD signals
while this unit is stopped, you can start recording
immediately.
In timeline mode, by simultaneously sending PLAY •
and RECORD signals during playback, you can start
overwriting the recording.
RS-232C connector
The RS-232C connector on the rear panel can be
connected to an RS-232C connector on a computer to
allow control of this unit from that computer.
Make settings related to communication on the RS-232C
page of the
REMOTE SETUP
screen. (See “RS-232C
page” on page 107.)
NOTE
Please contact TASCAM customer support for information
about this unit’s RS-232C command protocol.
RS-422 connector
You can control this unit remotely by connecting the RS-
422 connector on its rear panel to a controller or editor
compatible with the SONY P2 protocol (RS-422).
Use the REMOTE SETUP screen RS-422 page to make
settings related to operation. (See “RS-422 page” on page
108.)
NOTE
Please contact TASCAM customer support for information
about this unit’s protocol compatibility.