Teac HS-2000 - Manual (Page 41)

TASCAM HS-2000
41
5 – Projects
Editing the name of the first session
Touch the
Session Name
button on the
CREATE
PROJECT
screen to open the
1st SESSION
screen,
as shown below.
Follow the same procedures as in “Editing project names”
on page 40 to change the name.
NOTE
The name of a session cannot be changed after the
session is created.
Loading projects
1. Press the PROJECT key on the front panel to open the
PROJECT screen.
2. Select the project to load.
3. Touch the
MENU button on the PROJECT screen to
open its pull-up menu.
4. Touch the
LOAD
button in the pull-up menu.
NOTE
When multiple projects are selected, the
LOAD
item
cannot be used.
5. Touch the OK button or press the DATA dial when the
confirmation pop-up message appears.
After loading completes the Home Screen opens.
Rebuilding projects
You should rebuild a project whenever there is an
inconsistency between the unit's project management file
and the audio files. This can occur when an audio file has
been deleted from the unit via FTP, for example.
1. Press the PROJECT key on the front panel to open the
PROJECT
screen.
2. Select the project that you want to rebuild.
You can use the
MULTI SELECT
button on the
PROJECT
screen to allow the selection of multiple
projects.
3. Touch the
MENU
button on the
PROJECT
screen to
open its pull-up menu.
One project selected
Multiple projects selected
4. Touch the
REBUILD
button in the pull-up menu.
5. When a confirmation pop-up appears, touch the OK
button or press the DATA dial.
During rebuilding, a progress status pop-up appears.
When rebuilding completes, the pop-up disappears.
NOTE
If you select
REBUILD
when no project has been
selected in the
PROJECT
screen, the entire content of
the selected card will be rebuilt.