Teac HS-2000 - Manual (Page 73)

TASCAM HS-2000
73
8 – Take mode
4. Select the take that you want to load.
5. Touch the
MENU button in the take selection screen to
open the pull-up menu.
6. Touch the
LOAD
button in the pull-up menu.
7. When a confirmation pop-up appears, touch the
OK
button or press the DATA dial.
When loading completes, the Home Screen opens.
NOTE
You can also press the w button for a take to load it.
In this case, no pop-up appears, and the take selection
screen remains open after loading (the Home Screen does
not reopen).
Online function settings
Refer to “Online function” on page 129 to make online
output settings.
Setting input monitoring
Turn input monitoring OFF when you are playing back. If
input monitoring is ON, sound from the input connectors
will be output through all the output connectors of this
unit.
1. Touch the
INPUT MONITOR
button on the Home
Screen to open a pull-up with the input monitoring
ON/OFF button.
2. If input monitoring is on (
ON
button appears blue),
touch the OFF button to turn it off ( OFF button
appears blue).
Playback control in take mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP [RETAKE] key to stop playback.
Press the . [MARK.] key or /[MARK /] key
to skip to the next take.
Press and hold them[ ] or ,[ ] key to search
backward or forward.
Press the . [MARK.] or /[MARK /] key
while pressing and holding the SHIFT key to move
between marks.
Press and hold the m[ ] or ,[ ] key while
pressing and holding the SHIFT key to search at high-
speed.
NOTE
On the • PLAY SETUP
screen, you can set whether
only the currently selected take is played or whether
all the takes within the current session are played.
You can also enable and disable repeat playback. (See
“Playback settings (PLAY SETUP)” on page 102.)
Playback functions can also be performed using •
a remote control connected through the parallel
connector.
Using the call function
Press the CALL [CHASE] key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.