Teac HS-2000 - Manual (Page 21)

TASCAM HS-2000
21
2 − Names and functions of parts
k Time bar
This shows the current playback position according to
the time display mode.
Mode Meaning Bar display
Current playback
position relative to the
length of the take or
entry
Lengthens from left
end to right end
Shortens from left end
to right end
Current playback
position relative to the
length of all takes in the
session or the entire
playlist (white vertical
lines appear at take and
entry boundaries)
Lengthens from left
end to right end
Shortens from left end
to right end
Lengthens from left
end to right end
NOTE
During recording, a red progress bar lengthens from the
left end to the right end approximately every five seconds.
l Take/entry name display (button)
This shows the name and icon of the currently active
take or entry.
During recording standby, the file name that will be
given to the next recorded take is shown.
When in playlist mode, a “*” appears in the icon if the
playlist has not been saved after editing (including the
addition and removal of entries).
Touch to open a pull-down menu.
In take mode
TAKE List button
Opens the TAKE selection screen.
On the TAKE selection screen opened by this button,
pressing a session folder name area does not open the
SESSION selection screen. (See “Using the PROJECT
screen” on page 35.)
CIRCLE @ TAKE button
Adds or removes “@” at the beginning of the current
take name. (See “Take selection screen” on page 37.)
REBUILD button
Rebuilds the additional index files for HS-2000 when
files have been deleted or modified outside the unit
remotely using FTP, for example.
In playlist mode
ASSIGN FILE button
Opens the
ASSIGN
screen where you can assign files.
(See “ASSIGN File screen” on page 86.)
ENTRY LIST button
Opens the ENTRY list screen. (See “ENTRY list screen”
on page 84.)
ADJUST ENTRY button
Opens the
ADJUST ENTRY
*** screen where you
can edit entries. (See “Editing entry names” on page
88, “Editing playback starting/ending points” on page
89, “Editing playback starting times” on page 92 and
“Editing lengths and levels of fade-ins/outs” on page
92.)
REBUILD button
Rebuilds the additional index files for HS-2000 when
files have been deleted or modified outside the unit
remotely using FTP, for example.
SAVE button
Saves the current playlist. This can only be selected
when the transport is stopped.
(See “Saving playlists” on page 94.)
SAVE AS button
Rename and save the current playlist. This can only be
selected when the transport is stopped.
(See “Naming and saving a playlist” on page 94.)
CREATE PLAYLIST button
Opens the
PLAYLIST NAME
screen where you can
create a new playlist. (See “Creating a new playlist” on
page 82.)
; Level meters
These are the same as on the timeline mode Home
Screen.