Cutting the data in a selected area (cut), Erasing the data in the selected area (erase), 7 – timeline mode – Teac HS-2000 User Manual

Page 61

TASCAM HS-2000

7 – Timeline mode

Cutting the data in a selected area (Cut)

You can cut the data in a selected region. This copies it to

the copy buffer. The newly emptied area is then filled by

moving the session data after the OUT point of the cut

data forward to where its IN point was.

NOTE

Cut data will be retained in the copy buffer.

•

If an entire fade (in/out) area is included, the fade

•

information will also be retained.

If an IN or OUT point is within a region, any part of

•

the region outside of the cut area will become a new

region.

When the IN point or OUT point is within a fade in/out

•

area, the fade information will be deleted.

1. Press the HOME key on the front panel to open the

Home Screen.

2. Touch the

EDIT MODE

button to enter the edit

mode.

3. Move the timeline cursor to the area to be cut.
4. Touch the

SET/SELECT

button and set the area

you want to cut using the

SET IN

and

SET OUT

SELECT Region

buttons in the pull-up menu.

5. Touch the

EDIT

button to open a pull-up menu.

6. Touch the

Cut

button in the pull-up menu. When

cutting is complete, a pop-up window will appear

momentarily, and then the Home Screen will reopen.

In this case, the EDIT pull-up menu will remain open.

Erasing the data in the selected area

(Erase)

You can erase a selected region to make it silent. The

positions of any regions after the erased area will remain

unchanged.

NOTE

Erased data will be retained in the copy buffer.

•

If an entire fade (in/out) area is included, the fade

•

information will also be retained in the copy buffer.

When an IN or OUT point is within a region, any part

•

of the region outside of the area erased will become a

new region.

When the IN point or OUT point is set in a fade in/out

•

area, the fade information will be erased.