Teac HS-2000 - Manual (Page 51)

TASCAM HS-2000
51
7 – Timeline mode
Setting input monitoring
Turn input monitoring OFF during playback. If input
monitoring is ON, input signals will be output through all
output connectors.
1. Touch the
INPUT MONITOR
button on the Home
Screen to open a pull-up with the input monitoring
ON
/
OFF
button.
2. If input monitoring is
ON
(button appears blue), touch
the
OFF
button to turn it
OFF
(button appears blue).
Online function settings
Refer to "Online function" on page 129 to make online
output settings.
Locate to the playback start position
Use the m[ ] and , [ ] keys, jump to a mark
or use the manual locate function to locate to the time
where you want to start playback.
When timecode synchronization is ON, playback will occur
at the input timecode, so locating as described above is
not necessary.
Playback control in timeline mode
Press the PLAY key to start playback.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP [RETAKE] key to stop playback.
Press the . [MARK.] key or /[MARK/] key
to skip to the start of another region.
Press and hold the m[ ] or , [ ] key to search
backward or forward.
Press the . [MARK.] key or /[MARK/]
key while pressing and holding the SHIFT key to move
between marks.
Press and hold the m[ ] or , [ ] key while
pressing and holding the SHIFT key to search at high-
speed.
While pressing and holding the STOP key, press the .
[MARK.] key or /[MARK/] key to skip to the
beginning of the first region recorded or the end of the
last region. (This only works with the front panel keys.)
NOTE
Playback functions can also be performed using a remote
control connected through the parallel connector.
Using the call function
Press the CALL [CHASE] key to locate to the point where
playback was last started from playback standby (call
point) and put the unit in playback standby mode.
BWF-J cue point (timeline mode)
When the Follow BWF-J item is set to ON, if a BWF-J
cue point is detected during playback, the following
corresponding operation will occur. In addition, if the
BWF-J Tally Out item is set to ON, in response to each
BWF-J cue point, the CUE signal and tally signal will be
output from the parallel connector. However, when
playback is synchronized with timecode, only the cue and
tally signals will be output and the following operations
will not occur.
BC$STANDBY
When a session is loaded, the transport locates
to the first BC$STANDBY point that occurs and
pauses. During playback, playback pauses
when this cue point is detected. In either case,
a BC$STANDBY tally is output.
BC$CM
During playback, when this cue point is
detected, a BC$CM CUE signal is output.
BC$END
During playback, when this cue point is
detected, a BC$END CUE signal is output.
BC$STOP
During playback, when this cue point is
detected, a BC$STOP CUE signal is output, and
playback stops.
BC$FILE
During playback, when this cue point is
detected, a BC$END CUE signal is output.
BC$PAUSE
During playback, when this cue point is
detected, a BC$PAUSE tally is output, and
playback pauses.